Quick Tip: Nail Your Print-Then-Cut Alignment in One Test Print
The Registration Test (Page 1 of the PDF) is your fastest checkpoint. Print it at 100% scale on matte or coated inkjet paper — no scaling, sRGB color profile. Load the sheet into your Cricut, run the calibration cut, and measure the gap between the printed crosshairs and the cut lines.
- < 0.5 mm offset? You’re good to cut.
- > 0.5 mm? Reprint at 100%, verify printer scaling is off, and re-run.
Skip the guesswork: use the embedded crop/bleed marks (0.125″) to confirm the page didn’t shift during printing. One sheet, one cut, done.
